I have my stepper motors, I have my Pi - Now I would like to know how to 'marry' the two together... The end plan/result that I am after is a motorised rail for timelapse photo sequences. I would like the Pi to control the motors and trigger the shutter on my camera. eg move n-mm, pause for n-seconds, trigger shutter n-times - repeat... A friend has started writing the python for me (he is a whizz with all things python). I would like to know how to correctly wire the motors to the Pi. I have a photo of the '?control board that came with the motors.
- motor chip and pins.jpg (56.65 KiB) Viewed 2428 times
There seems to be a jumper over the pins VCC & VM. The only thing I think I might know is that pin GND is the ground pin...
Any and all help is truly appreciated